- You cannot add "Stern (rear) cap for a 50mm Tube." to the cart because the product is out of stock.
€329.90
WTC KIT with the Fitting (conversion) KIT for the Trumpeter Russian Kilo Class Submarine (Trumpeter number: o5903).
2 in stock
Description
WTC Kit for Trumpeter “Russian Kilo Class Attack Submarine” (o5903).
Version with fitting (conversion) kit.
Measurements:
Outer tube diameter: 50mm/1,96″
WTC external length (including cap ends and servo pushrods with magnetic couplers): 400 mm/15,75 inches
WTC Length (from one end cap to another): 330 mm/13 inches
Polycarbonate tube length: 300 mm/11.8 inches
Weight: 590 gram
This setup includes:
- Fitting KIT (conversion KIT) for Trumpeter Kilo 1:144
- Pump
- Pump controller
- Drive motor
- ESC for drive motor
- Li-Ion battery pack (4 cells, 7.4V 1300mAh)
- PDF Assembly Manual (English)
- All plastic parts for the water tight container assembly
- Ballast tank with “quick lock” connector for easy replacement.
- Necessary brass tubing
- Necessary silicon tubing
- Main drive seal
- 2 Pushrods seals
- Pushrods
- Magnetic connectors (3 pairs)
- Polycarbonate tube
- Bow (front) end cap
- Stern (rear) end cap
- End cap seals
- all necessary screws, nuts and threads
The included fitting kit allows for an easy connection of the WTC with the plastic model. It’s especially designed for the Trumpeter Kilo and most likely will not fit other models. The fitting kit also allows for a perfect alignment of the upper and lower hull.
Fitting Kit for Trumpeter Kilo consists of :
- 5x ribs as the WTC mount, they also allow for perfect alignment of the upper and lower hull.
- 2x Magnetic shaft connectors (Pair joining the propeller shaft with motor shaft).
- Bow plate for locking the upper hull half
- Aft plate for locking the upper hull half
- WTC aft endstop
- External rib for the Kilo bow planes pushrod (with magnetic coupler)
Still required to make the WTC operational:
- RC receiver and radio transmitter.
- 2 x micro servos (Corona CS-939MG recommended)
Trumpeter Kilo 1:144 model not included!
This is an unassembled KIT. It requires some basic knowledge and experience about RC models. It also requires some precision and patience, but allows to construct a fully operational WTC, exactly like the one on the photos.
For the assembled, ready to use version of the WTC CLICK HERE.
The building thread of my personal Trumpeter Kilo with lots of photos can be found HERE.
