€309.90
WTC Kit with O.D. of 50mm/1.96inch. DOES NOT include any fitting kit.
2 in stock
Description
WTC Kit for small Trumpeter models. No Fitting KIT.
Fits Trumpeter models:
-
Trumpeter Russian Kilo Class Submarine (Trumpeter number: o5903)
-
Trumpeter Japanese Soryu Class Attack Submarine (Trumpeter number: 05911)
Measurements:
Outer tube diameter: 50mm/1,96inch
WTC external length (including cap ends and servo pushrods with magnetic couplers): 400 mm/15,75 inches
WTC Length (from one end cap to another): 330 mm/13 inches
Polycarbonate tube length: 300 mm/11.8 inches
Weight: 590 gram
This setup includes:
- Pump
- Pump controller
- Drive motor
- ESC for drive motor
- Li-Ion battery pack (4cells, 7.4V 1300mAh)
- PDF Assembly Manual (English)
- All plastic parts for the water tight container assembly
- Ballast tank with “quick lock” connector for easy replacement.
- Necessary brass tubing
- Necessary silicon tubing
- Main drive seal
- 2 Pushrods seals
- Pushrods
- Magnetic connectors (3 pairs)
- Polycarbonate tube
- Bow (front) end cap
- Stern (rear) end cap
- End cap seals
- all necessary screws, nuts and threads
Still required to make the WTC operational:
- RC receiver and radio transmitter.
- 2 x micro servos (Corona CS-939MG recommended)
WTC in the Trumpeter Russian Kilo Class Submarine (Trumpeter number: o5903):
WTC in the Trumpeter Japanese Soryu Class Attack Submarine (Trumpeter number: 05911):
Not included:
Fitting KIT not included!
Trumpeter models not included!
This is an unassembled KIT. It requires some basic knowledge and experience about RC models. It also requires some precision and patience, but allows to construct a fully operation WTC, exactly like the one on the photos.
This is the WTC, which I have used for building my personal Trumpeter Kilo. You can see the building thread with lots of photos can be found HERE.
